Skip to main content
d o t logo United States Department of Transportation
For your protection, your login session will expire in 0 minutes and 0 seconds. Do you wish to extend your session or logout?
For your protection, your login session has expired and you are required to login
Top
Home My Safety Planner (Chapters) 5.0 5.1 Sleeper Berths (393.76) 5.1.11 Sleeper Berths (393.76)
downloadDownload
printPrint
 
 
Note:
This is an excerpt from FMCSA's Motor Carrier Safety Planner specific to your interests. As you navigate through the pages, pay close attention to any notes and highlights. Click here to read the entire Safety Planner and find more resources to help you comply with safety regulations.

5.1.11 Sleeper Berths (393.76)

Sleeper berths must meet minimum dimension and installation guidelines. Sleeper berths must be adequately ventilated, and located so that occupants are protected against exhaust heat and fumes, and fuel leaks.

For sleeper berths installed before 1975, please refer to the special provisions in 49 CFR 393.76.

See 49 CFR 393.76 for complete requirements on sleeper berths.
Disclaimer
This publication is distributed by the U.S. Department of Transportation, Federal Motor Carrier Safety Administration (FMCSA). It is meant to serve as a guide only and the Agency does not assume responsibility for any omissions, errors, or ambiguity contained herein. The contents may not be relied upon as a substitute for the Agency’s published regulations.

Stay Connected:

contactContact Us

rss